Insulation Energy Conservation Material

Insulation energy conservation material for you home. The Geek says, "keep the cool air in for the summer and the hot air in during the winter!"

Rolls and batts—or blankets—are flexible products made from mineral fibers, such as fiberglass and rock wool. They are available in widths suited to standard spacings of wall studs and attic or floor joists: 2x4 walls can hold R-13 or R-15 batts; 2x6 walls can have R-19 or R-21 products.

Loose-fill insulation—usually made of fiberglass, rock wool, or cellulose in the form of loose fibers or fiber pellets, it should be blown into spaces using special pneumatic equipment. The blown-in material conforms readily to building cavities and attics. Therefore, loose-fill insulation is well suited for places where it is difficult to install other types of insulation.

Rigid foam insulation—foam insulation typically is more expensive than fiber insulation. But it's very effective in buildings with space limitations and where higher R-values are needed. Foam insulation R-values range from R-4 to R-6.5 per inch of thickness, which is up to 2 times greater than most other insulating materials of the same thickness.

Foam-in-place insulation—this type can be blown into walls and reduces air leakage, if blown into cracks, such as around window and door frames.

Insulation Tips

• Consider factors such as your climate, building design, and budget when selecting insulation R-values for your home.
• Use higher density insulation on exterior walls, such as rigid foam boards, in cathedral ceilings and on exterior walls.
• Ventilation helps with moisture control and reducing summer cooling bills. Attic vents can be installed along the entire ceiling cavity to help ensure proper airflow from the soffit to the attic to make a home more comfortable and energy efficient. Do not ventilate your attic if you have insulation on the underside of the roof. Check with a qualified contractor.
• Recessed light fixtures can be a major source of heat loss, but you need to be careful how close you place insulation next to a fixture unless it is marked IC—designed for direct insulation contact. Check your local building codes for recommendations. See Lighting for more about recessed cans.
• As specified on the product packaging, follow the product instructions on installation and wear the proper protective gear when installing insulation.

Hope these insulation energy conservation materials helped out! Remember, one of the most cost-effective ways to make your home more comfortable year-round is to add insulation to your attic.

Energy Saving Tips main page

Return from Insulation Energy Conservation Material page to Alternative Energy Geek home page.